Zolt X XL Mod Kit
Includes:- 1 x Zolt body
- 2 x 18650 battery (1800mAh)
- 1 x 510 3.0ohm atomizer
- 1 x Drip Tip
- 1 x Charger(single slot)
- 1 x User manual
- 1 x Zipper case
- 90 day warranty
Tech Specs:Selectable voltage from 3v to 6v in 0.1v increments Power on/Off Button: Hold the red power button down for 5 seconds to turn the device on, hold the button again for 5 seconds to turn the device off. + Button: On press, increases voltage by .1 increments between 3volt and 6 volt. When you reach 6 volts, the user starts back at 3 volts - Button: On press, decreases voltage by .1 increments between 3volt and 6 volt. When you reach 3 volts, the user starts back at 6 volts + and Ñ Button: Press and hold both buttons for five second to disable the + and Ñ button, locking the device on the voltage it is currently set at. Regulated Output: Keeps the voltage the same with each puff - regardless of the remaining battery power. As the battery drains, the device will keep the voltage consistent. If the activation button is held down for 10 seconds or longer, the device will shut itself off until the button is released, to prevent overheating the atomizer and the device. Short Circuit/Atomizer Protection: The device can recognize an atomizer with too low of a resistance for the current voltage setting and will drop the voltage to 3.7v to protect both the battery and atomizer. If the atomizer is too low or shorted out it will shut off power to the device to protect the device from being damaged. Reverse Battery Protection: Protects the device in case you put the battery in the device backwards Battery Monitoring/Over-Discharge Protection: The device will monitor the battery voltage and automatically turn off when the battery is discharged, preventing damage to the battery by overly depleting it. Battery Voltage Meter: Has a voltage meter built in, simply press the red power button 5 times and it will display the voltage of the battery for a few seconds. This way you can monitor the power left in the battery before it needs to be recharged. High Drain (IMR) batteries provide 4.2v at peak charge and over the life of the battery that voltage will decrease to about 3.3v level before needing to be recharged. The LCD screen will flash when the battery needs to be recharged, and will stop powering the device. Vent hole on the bottom of the device for added safety |
